Page 1 of 1

--Way to simulate a "warm" lighting effect with Co

Posted: Thu Oct 07, 2004 8:30 pm
by Montanan

i have colorwasher plugin, and use it with irfanview.

Is their a way I can not only colorwash an image, but also add a "warming effect filter" to the image at the same time?

I have messed around some with color temperature settings, but it seems to through off the auto features of colorwasher. Just not sure of correct procedure.



Posted: Fri Oct 08, 2004 11:35 am
by HaraldHeim
To color correct a photo and add a color effect at the same time, you have to do the color correction at first.

Then you select the Target color box and change its color from gray to a slightly colored "gray" by using the three sliders below. Doing that with the Color Temp. color model is a bit difficult, because when you switch to it, it doesn't keep the gray tone. So better use the RGB or HSL sliders.